EXIT MOULD TRIGGER 500ML

Exit Mould

$15.40 AUD
$15.40 AUD $0.00 AUD
Tax included. Shipping calculated at checkout.
New
Exit Mould attacks moulds at the source and the special detergent additive helps leave the surface sparkling clean. Can be used indoors and outdoors.- Bathroom and laundry.- Tiles, grout and walls.- Rubber bath mats.- Fridge door seals.- Boats.- Under eaves.- Concrete patios.- Most mouldy areas.

Description

GimmeNow

1. Pointing trigger away from the face, hold down the safety tab on top of the nozzle. 2. Turn nozzle to ON position. Do not squeeze the trigger when it is in OFF position as this may cause it to spit when turned ON. 3. Spray from 20-30cm away from targeted area. Leave for 30s for light stains and 10 mins for tough stains. 4. Rinse with water and then wipe off. Repeat steps 2 to 4 if required. 5. When finished, turn nozzle to OFF position, until safety tab locks in position.

Sodium Hydroxide 2.4g/L Alkaline Salts 1.2g/L Sodium Hypochlorite 42g/L

Do not swallow. Vapour maybe harmful. Ensure adequate ventilation when using. May give off dangerous gas if mixed with other products. Wear protective gloves when using. Wear either old clothes, or a protective covering as product can cause discolouration of clothing and textiles. Wash hands after use. NOT TO BE TAKEN. Corrosive. Strongly alkaline. May produce severe burns. Attacks skin and eyes. Keep out of reach of children. Read safety directions before using. Turn nozzle to off position after use. Do not squeeze trigger in OFF position as this may cause product to spit when turned ON.

Dimensions

Product estimated dimensions:

Length 10 cm, Width 5 cm, Height 25 cm

EXIT MOULD TRIGGER 500ML

$15.40 AUD